Model Number: TH115-zyy0402
Brand Name: eoutil
Key Specifications/Special Features:
Key Specifications/Special Features:1) LCD display & audible with backlight2) Detect wood and metal stud up to 3/4in 19mm Detect metal rebar up to 3in 76mm Detect AC live wire up to 3in 76mm3) all functions auto calibration4) Operated by on pieces of 9V battery5) Size: 68.5*28.9*160mm6) Weight:108.3g
POWER SUPPLY
The tools require one 9 volt battery to operate
BATTERY INSTALLATION
1. Open battery door on back of case.
2. Connect a 9-volt battery to battery clip.
3. Insert battery into case and replace battery
Stud Scan or Deep Scan modes
Stud Scan mode for depths to about 11/2 in. (30mm).
Position the Scanner Flat against theWall.
Select mode. Press and hold on/off button sounds off the auto finish
Slowly slide unit horizontally across wall, right of left.
When full bars appears on the LCD and steady tone sounds, you have located the edge of the stud. Mark this spot.
Continue holding on/off button in and scan beyond the marked spot until bars disappears.
Scanning in AC mode
AC depths to about 2 in.
Select AC scan mode to determine position
of hot wires. Begin by placing the scanner
at some position away from hot wiring.
While holding in the on/off button, slowly slide unit across the wall. AC indicator will appear on LCD if a hot wire is nearby. LCD display indicates proximity to hot wire all bars indicating closest proximity. Mark this mark. The scanner detects from 90V to 250V at 50 to 60 Hz AC in a HOT electrical wire. The voltage detection feature works continuously in all modes for safety
By certification [File Integrity]
